Only had to assemble and disassemble it about 8 times. The grease fitting that came with it would not fit, nor would a 90 deg grease fitting. Finally found a short grease fitting that fit. I can only grease it with the drive shaft unhooked and had to file flat spots on the grease gun end to get it on the fitting.
Here it is installed.
In case anyone wondered, the transmission side is a straight bore PTO yoke with set screws on both sides. I looked and could not find a 10 spline 15/16 diameter u joint yoke. This is what was on it when I purchased the tractor and has worked good so far.
Here is a video of the driveline running.
No comments:
Post a Comment